Ôn tập Cisco packet tracer Routing Protocols and Concepts - Môn mô phỏng các hệ thống truyền thông
Ôn tập Cisco packet tracer Routing Protocols and Concepts - Môn mô phỏng các hệ thống truyền thông
Contents at a GlanceIntroduction xxv
Chapter 1 Introduction to Routing and Packet Forwarding 1
Chapter 2 Static Routing 69
Chapter 3 Introduction to Dynamic Routing Protocols 139
Chapter 4 Distance Vector Routing Protocols 169
Chapter 5 RIP Version 1 189
Chapter 6 VLSM and CIDR 245
Chapter 7 RIPv2 307
Chapter 8 The Routing Table: A Closer Look 357
Chapter 9 EIGRP 393
Chapter 10 Link-State Routing Protocols 474
Chapter 11 OSPF 495
The console port is a management port used to provide out-of-band access to a router. It is used to set
up the initial configuration of a router and to monitor it.
A rollover cable and an RJ-45–to–DB-9 adapter are used to connect a PC to the console port. As you
know from your previous studies, terminal emulation software is used to configure the router over the
console connection. The Cisco Networking Academy Program recommends using Tera Term.
However, you can also use HyperTerminal, which is part of the Windows operating system.
At the end of this lab, the following three appendices are available for your reference concerning these
two terminal emulation programs:■ Appendix 1A: Installing and Configuring Tera Term for Use in Windows XP■ Appendix 1B: Configuring Tera Term as the Default Telnet Client in Windows XP■ Appendix 1C: Accessing and Configuring HyperTerminal
Chapter 1 Introduction to Routing and Packet Forwarding 1
Chapter 2 Static Routing 69
Chapter 3 Introduction to Dynamic Routing Protocols 139
Chapter 4 Distance Vector Routing Protocols 169
Chapter 5 RIP Version 1 189
Chapter 6 VLSM and CIDR 245
Chapter 7 RIPv2 307
Chapter 8 The Routing Table: A Closer Look 357
Chapter 9 EIGRP 393
Chapter 10 Link-State Routing Protocols 474
Chapter 11 OSPF 495
The console port is a management port used to provide out-of-band access to a router. It is used to set
up the initial configuration of a router and to monitor it.
A rollover cable and an RJ-45–to–DB-9 adapter are used to connect a PC to the console port. As you
know from your previous studies, terminal emulation software is used to configure the router over the
console connection. The Cisco Networking Academy Program recommends using Tera Term.
However, you can also use HyperTerminal, which is part of the Windows operating system.
At the end of this lab, the following three appendices are available for your reference concerning these
two terminal emulation programs:■ Appendix 1A: Installing and Configuring Tera Term for Use in Windows XP■ Appendix 1B: Configuring Tera Term as the Default Telnet Client in Windows XP■ Appendix 1C: Accessing and Configuring HyperTerminal
Nhận xét